U2160 BMW Fault Code

Description:

Brake Switch Circuit Input Malfunction Indicates PCM did not receive a brake pedal position (BPP) input. Open or short in BPP circuit Open or short in stoplamp circuits damaged PCM Malfunction in module(s) connected to BPP circuit.

(Rear Electronic Module [REM] Windstar and LS6/LS8 or Lighting Control Module (LCM) Continental and Town Car. Damaged brake switch Misadjusted brake switch Check for proper function of stoplamps.

U2160 Code Symptoms :

When you turn on the ignition, the Service Engine Soon or Check Engine U2160 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the U2160!

Diagnosis And Repairing U2160

U2160 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to fix U2160 code ?

• Damaged ECM
• Faulty oil control valve (OCV)
• Incorrect fuel filler cap used
• Faulty Air Flow Meter

Gear changes are accomplished by a command from the BMW TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.